Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Practice for Calibration Techniques Using Permeation Tubes
Automaticky přeložený název:
Standardní praxe pro kalibrační techniky využívající prostupování trubky
NORMA vydána dne 1.9.2014
Označení normy: ASTM D3609-00(2014)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.9.2014
Kód zboží: NS-24208
Počet stran: 5
Přibližná hmotnost: 15 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
analyzers, butane permeation tubes, calibration, CL2 permeation tubes, gas permeable tubes, H2S permeation tubes, NH3 permeation tubes, NO2 permeation tubes, propane permeation tubes, SO2 permeation tubes, ICS Number Code 17.020 (Metrology and measurement in general)
Significance and Use | ||||
5.1 Most analytical methods used in air pollutant measurements are comparative in nature and require calibration or standardization, or both, often with known blends of the gas of interest. Since many of the important air pollutants are reactive and unstable, it is difficult to store them as standard mixtures of known concentration for extended calibration purposes. An alternative is to prepare dynamically standard blends as required. This procedure is simplified if a constant source of the gas of interest can be provided. Permeation tubes provide this constant source, if properly calibrated and if maintained at constant temperature. Permeation tubes have been specified as reference calibration sources, for certain analytical procedures, by the Environmental Protection Agency (3). |
||||
1. Scope | ||||
1.1 This practice describes a means for using permeation tubes for dynamically calibrating instruments, analyzers, and analytical procedures used in measuring concentrations of gases or vapors in atmospheres (1, 2).2 1.2 Typical materials that may be sealed in permeation tubes include: sulfur dioxide, nitrogen dioxide, hydrogen sulfide, chlorine, ammonia, propane, and butane 1.3 The values stated in SI units are to be regarded as standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||
2. Referenced Documents | ||||
|
Historická
28.3.2013
Historická
1.8.2013
Historická
1.3.2010
Historická
1.10.2008
Historická
15.11.2011
Historická
1.8.2013
Poslední aktualizace: 23.12.2024 (Počet položek: 2 217 157)
© Copyright 2024 NORMSERVIS s.r.o.