Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Average Velocity in a Duct Using a Thermal Anemometer
Přeložit název
NORMA vydána dne 1.1.2023
Označení normy: ASTM D3464-96(2023)
Datum vydání normy: 1.1.2023
Kód zboží: NS-1102497
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
air velocity, anemometer, atmospheres, gas velocity, hot wire anemometer, measurements, pitot tube, thermal anemometer,, ICS Number Code 17.120.10 (Flow in closed conduits)
Significance and Use | ||||||
5.1?The method presented is a short method that may be used where contamination levels are less than 5000 ppm by weight or volume, temperatures are between 0 ?C (32 ?F) and 65 ?C (150 ?F), and the humidity is not considered. The gas is considered as standard air and the velocity is read directly from the instrument. 5.2?This test method is useful for determining air velocities in HVAC ducts, fume hoods, vent stacks of nuclear power stations, and in performing model studies of pollution control devices. |
||||||
1. Scope | ||||||
1.1?This test method describes the measurement of the average velocity with a thermal anemometer for the purpose of determining gas flow in a stack, duct, or flue 1.2?The range of the test method is from 1 to 30 m/s (3 to 100 ft/s). 1.3?The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard. 1.4?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||
2. Referenced Documents | ||||||
|
Poslední aktualizace: 22.11.2024 (Počet položek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.