Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Coated Fabrics—Waterproofness
Přeložit název
NORMA vydána dne 1.10.2022
Označení normy: ASTM D3393-91(2022)
Datum vydání normy: 1.10.2022
Kód zboží: NS-1088701
Počet stran: 2
Přibližná hmotnost: 6 g (0.01 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
This specification establishes the minimum requirements for the hydrostatic resistance or ""waterproofness"" of fabrics coated with rubber or plastics. This document does not cover water repellency or water resistance of the same materials. The test specimens should be cut to specifications and at random from a roll of coated fabric. The hydrostatic tester should be able to apply the required amount of pressure and sustain it for a specified time. The apparatus should be equipped with two concentric ring clamps with rounded inside edges to avoid cutting the specimen. The lower clamp should be fitted with a seal to prevent leakage during testing.
Keywords:
coated fabrics, hydrostatic resistance, waterproofness ,, ICS Number Code 59.080.40 (Coated fabrics)
Significance and Use | ||||
5.1?The purpose of this specification is to establish a recognized criterion for waterproofness in terms of a minimum hydrostatic resistance. The necessary definitions to provide a common understanding of the meaning of this characteristic when it is used to describe a fabric coated with rubber or plastics are also given. The specification does not cover requirements for water repellency or water resistance of fabrics coated with rubber or plastics. |
||||
1. Scope | ||||
1.1?This specification sets forth the minimum requirements for hydrostatic resistance of fabrics coated with rubber or plastics. Coated fabrics satisfying these requirements are considered to be 1.2?The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only. 1.3?The following precautionary caveat pertains only to the test method portion of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||
2. Referenced Documents | ||||
|
Poslední aktualizace: 03.11.2024 (Počet položek: 2 209 203)
© Copyright 2024 NORMSERVIS s.r.o.