Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM D3213-13e1
Standard Practices for Handling, Storing, and Preparing Soft Intact Marine Soil (Includes all amendments And changes 2/8/2019).
Přeložit název
NORMA vydána dne 1.11.2013
Informace o normě:
Označení normy: ASTM D3213-13e1
Poznámka: NEPLATNÁ
Datum vydání normy: 1.11.2013
Kód zboží: NS-844646
Počet stran: 5
Přibližná hmotnost: 15 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM D3213-13e1 :
Keywords:
laboratory fine-grained soils, marine, soft, storage, intact samples,, ICS Number Code 07.060 (Geology. Meteorology. Hydrology)
Doplňující informace
| Significance and Use | ||||||||||||||||||
|
5.1 Disturbance imparted to sediments after sampling can significantly affect some geotechnical properties. Careful practices need to be followed to minimize soil fabric changes caused from handling, storing, and preparing sediment specimens for testing. 5.2 The practices presented in this
document should be used with soil that has a very soft or soft
shear strength (undrained shear strength less than 25 kPa (3.6
psi)) consistency.
5.3 These practices shall apply to
specimens of naturally formed marine soil (that may or may not be
fragile or highly sensitive) that will be used for density
determination, consolidation, permeability testing or shear
strength testing with or without stress-strain properties and
volume change measurements (see Note 3). In addition, dynamic and
cyclic testing can also be performed on the sample.
5.4 These practices apply to
fine-grained soils that do not allow the rapid drainage of pore
water. Although many of the procedures can apply to coarser-grained
soils, drainage may occur rapidly enough to warrant special
handling procedures not covered in these practices.
5.5 These practices apply primarily to soil specimens that are obtained in thin-walled or similar coring devices that produce high-quality cores or that are obtained by pushing a thin-walled tube into cores taken with another sampling device. 5.6 These practices can be used in conjunction with soils containing gas, however, more specialized procedures and equipment that are not covered in these practices have been developed for use with such materials. 1.1 These practices cover methods
for project/cruise reporting, and handling, transporting and
storing soft cohesive intact marine soil. Procedures for preparing
soil specimens for triaxial strength, and consolidation testing are
also presented.
1.2 These practices may include the handling and transporting of sediment specimens contaminated with hazardous materials and samples subject to quarantine regulations. 1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard. 1.4 These practices offer a set of instructions for performing one or more specific operations. This document cannot replace education or experience and should be used in conjunction with professional judgment. Not all aspects of these practices may be applicable in all circumstances. This ASTM standard is not intended to represent or replace the standard of care by which the adequacy of a given professional service must be judged, nor should this document be applied without consideration of a project’s many unique aspects. The word “Standard” in the title means only that the document has been approved through the ASTM consensus process. 1.5 This standard does not
purport to address all of the safety concerns, if any, associated
with its use. It is the responsibility of the user of this standard
to establish appropriate safety and health practices and determine
the applicability of regulatory limitations prior to use.
Standard Practice for X-Ray Radiography
of Soil Samples Standard Practice for Minimum
Requirements for Agencies Engaged in Testing of Soil and Rock as
Used in Engineering Design and Construction Standard Test Method for One-Dimensional
Consolidation Properties of Saturated Cohesive Soils Using
Controlled-Strain Loading Standard Test Method for
Unconsolidated-Undrained Triaxial Compression Test on Cohesive
Soils Standard Terminology Relating to Soil,
Rock, and Contained Fluids (Includes all amendments and changes
6/15/2026). Standard Practice for Thin-Walled Tube
Sampling of Soils for Geotechnical Purposes Standard Test Methods for One-Dimensional
Consolidation Properties of Soils Using Incremental Loading Standard Practice for Description and
Identification of Soils for Engineering Purposes (Visual-Manual
Procedures) Standard Practices for Preserving and
Transporting Soil Samples |
Doporučujeme:
Aktualizace zákonů
Chcete mít jistotu o platnosti užívaných předpisů?
Nabízíme Vám řešení, abyste mohli používat stále platné (aktuální) legislativní předpisy.
Chcete vědět více informací? Podívejte se na tuto stránku.
