Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Estimating Apparent Vapor Pressures and Molecular Weights of Lubricating Oils
Automaticky přeložený název:
Standardní testovací metoda pro odhad Zjevné tlaky páry a molekulovou hmotností mazacích olejů
NORMA vydána dne 1.1.2016
Označení normy: ASTM D2878-10(2016)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.1.2016
Kód zboží: NS-631926
Počet stran: 6
Přibližná hmotnost: 18 g (0.04 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
lubricating oils, molecular weight, vapor pressure,, ICS Number Code 75.100 (Lubricants, industrial oils and related products)
Significance and Use | ||||||||||||||
5.1 The vapor pressure of a substance as determined by measurement of evaporation reflects a property of the bulk sample. Little weight is given by the procedure to the presence of low concentrations of volatile impurities. 5.2 Vapor pressure, per se, is a thermodynamic property that is dependent only upon composition and temperature for stable systems. In the present method, composition changes occur during the course of the test so that the contribution of minor amounts of volatile impurities is minimized. |
||||||||||||||
1. Scope | ||||||||||||||
1.1 This test method covers a calculation procedure for converting data obtained by Test Method D972 to apparent vapor pressures and molecular weights. It has been demonstrated to be applicable to petroleum-based and synthetic ester lubricating oils,2 at temperatures of 395 K to 535 K (250 °F to 500 °F). However, its applicability to lubricating greases has not been established. Note 1: Most lubricants boil over a fairly wide temperature
range, a fact recognized in discussion of their vapor pressures.
For example, the apparent vapor pressure over the range 0 % to
0.1 % evaporated may be as much as 100 times that over the range
4.9 % to 5.0 % evaporated.
1.2 The values stated in SI units are to be regarded as the standard. In cases in which materials, products, or equipment are available in inch-pound units only, SI units are omitted. 1.3 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability or regulatory limitations prior to use. For specific warning statements, see 6.2, 7.1, 8.2, and Annex A2. |
||||||||||||||
2. Referenced Documents | ||||||||||||||
|
Poslední aktualizace: 03.05.2024 (Počet položek: 2 896 946)
© Copyright 2024 NORMSERVIS s.r.o.