Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Apparent Viscosity of Petroleum Waxes Compounded with Additives (Hot Melts) (Includes all amendments And changes 7/6/2016).
Automaticky přeložený název:
Standardní zkušební metoda pro zdánlivá viskozita minerálních vosků Směsný se přídatné látky (Hot taje)
NORMA vydána dne 15.4.2012
Označení normy: ASTM D2669-06(2012)e1
Poznámka: NEPLATNÁ
Datum vydání normy: 15.4.2012
Kód zboží: NS-21101
Počet stran: 6
Přibližná hmotnost: 18 g (0.04 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
Additives--petroleum products, Brookfield viscometer, Hot melts, Petroleum wax, Viscosity--petroleum products, ICS Number Code 75.140 (Waxes, bituminous materials and other petroleum products)
Significance and Use | ||
This test distinguishes between hot melts having different apparent viscosities. It is believed that apparent viscosity determined by this procedure is related to flow performance in application machinery operating under conditions of low shear rate. Apparent viscosity as determined by this method may not correlate well with end use applications where high shear rates are encountered. Materials of the type described in this procedure may be quite non-Newtonian and as such the apparent viscosity will be a function of shear rate under the conditions of test. Although the viscometer described in this test generally operates under conditions of relatively low shear rate, differences in shear effect can exist depending upon the spindle and rotational speed conditions selected for the test program. Maximum correlation between laboratories, therefore, depends upon testing under conditions of equivalent shear. |
||
1. Scope | ||
1.1 This test method covers the determination of the apparent viscosity of petroleum waxes compounded with additives (hot melts). It applies to fluid hot melts having apparent viscosities up to about 20 Pa·s at temperatures up to 175°C (347°F). Note 1—For petroleum waxes and their blends having low apparent viscosities, below about 15 mPa·s, Test Method D445, is especially applicable. 1.2 The values stated in SI units shall be regarded as the standard. One pascal second (Pa·s) = 1000 centipoises (cP). One millipascal second (mPa·s) = 1 centipoise (cgs units). 1.3 WARNINGMercury has been designated by many regulatory agencies as a hazardous material that can cause central nervous system, kidney and liver damage. Mercury, or its vapor, may be hazardous to health and corrosive to materials. Caution should be taken when handling mercury and mercury containing products. See the applicable product Material Safety Data Sheet (MSDS) for details and EPA’s websitehttp://www.epa.gov/mercury/faq.htmfor additional information. Users should be aware that selling mercury and/or mercury containing products into your state or country may be prohibited by law. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||
2. Referenced Documents | ||
|
Poslední aktualizace: 12.09.2024 (Počet položek: 2 346 316)
© Copyright 2024 NORMSERVIS s.r.o.