Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Specular Gloss of Plastic Films and Solid Plastics
Přeložit název
NORMA vydána dne 1.5.2021
Označení normy: ASTM D2457-21
Datum vydání normy: 1.5.2021
Kód zboží: NS-1026833
Počet stran: 6
Přibližná hmotnost: 18 g (0.04 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
gloss, plastic films, solid plastics,, ICS Number Code 83.140.10 (Films and sheets)
Significance and Use | ||||||||||||||
4.1?Specular gloss is used primarily as a measure of the shiny appearance of films and surfaces. Precise comparisons of gloss values are meaningful only when they refer to the same measurement procedure and same general type of material. In particular, gloss values for transparent films should not be compared with those for opaque films, and vice versa. Gloss is a complex attribute of a surface which cannot be completely measured by any single number. 4.2?Specular gloss usually varies with surface smoothness and flatness. It is sometimes used for comparative measurements of these surface properties. |
||||||||||||||
1. Scope | ||||||||||||||
1.1?This test method describes procedures for the measurement of gloss of plastic films and solid plastics, both opaque and transparent. It contains four separate gloss angles (Note 1): 1.1.1?60-deg, recommended for intermediate-gloss films, 1.1.2?20-deg, recommended for high-gloss films, 1.1.3?45-deg, recommended for intermediate and low-gloss films, 1.1.4?85-deg, recommended for intermediate and low gloss films, and 1.1.5?75-deg, recommended for plastic siding and soffit. Note 1:?The 85-deg, 75-deg, 60-deg, and 20-deg apparatus and
method of measurement duplicate those in Test Method D523 and D3679; those for the 45? procedure are
similarly taken from Test Method C346.
1.2?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Note 2:?There is no known ISO equivalent to this
standard.
1.3?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||
2. Referenced Documents | ||||||||||||||
|
Poslední aktualizace: 01.11.2024 (Počet položek: 2 208 817)
© Copyright 2024 NORMSERVIS s.r.o.