Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Calorific (Heating) Value of Gases in Natural Gas Range by Continuous Recording Calorimeter
Přeložit název
NORMA vydána dne 1.4.2017
Označení normy: ASTM D1826-94(2017)
Datum vydání normy: 1.4.2017
Kód zboží: NS-680930
Počet stran: 10
Přibližná hmotnost: 30 g (0.07 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
calorific value, calorimeter, gaseous fuels, natural gases ,, ICS Number Code 17.200.10 (Heat. Calorimetry), 75.160.30 (Gaseous fuels)
Significance and Use | ||||||||||||||||||||||||||||||||||||||||||||||||||||||
4.1 This test method provides an accurate and reliable method to measure the total calorific value of a fuel gas, on a continuous basis, which is used for regulatory compliance, custody transfer, and process control. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||
1. Scope | ||||||||||||||||||||||||||||||||||||||||||||||||||||||
1.1 This test method covers the determination with the continuous recording calorimeter (Note 1) of the total calorific (heating) value of fuel gas produced or sold in the natural gas range from 900 to 1200 Btu/standard ft3. Note 1: An extensive investigation of the accuracy of the
Cutler-Hammer recording gas calorimeter, when used with gases of
high heating value, was made by the National Bureau of Standards in
1957 under a research project sponsored by the American Gas
Association.
1.2 The subjects covered in this test method appear in the following sections:
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||
Poslední aktualizace: 23.12.2024 (Počet položek: 2 217 157)
© Copyright 2024 NORMSERVIS s.r.o.