Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Brittleness Temperature of Plastic Sheeting by Impact
Automaticky přeložený název:
Standardní zkušební metoda pro křehkosti Teplota plastových fólií při nárazu
NORMA vydána dne 1.10.2008
Označení normy: ASTM D1790-08
Poznámka: NEPLATNÁ
Datum vydání normy: 1.10.2008
Kód zboží: NS-18395
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
brittleness temperature, cold-crack temperature, impact, plastic sheeting, Brittleness temperature, Cold-crack temperature, Impact testing--plastics, Plastic sheet and film, ICS Number Code 83.140.10 (Films and sheets)
Significance and Use | ||||||||||||
Data obtained by this test method have been used to predict the behavior of plastic sheeting at low temperatures only if the conditions of deformation are similar to those specified in this test method. This test method is useful for specification testing and for comparative purposes, but does not necessarily determine the lowest use temperature for a particular plastic. It has been demonstrated that on calendered sheeting the brittleness temperature is sensitive to the direction of fold. It has also been demonstrated that the brittleness temperature is sensitive to the direction of sampling. Therefore, it is imperative that the procedure for taking specimens and folding be followed explicitly. |
||||||||||||
1. Scope | ||||||||||||
1.1 This test method covers the determination of that temperature at which plastic sheeting 1.00 mm (0.040 in.) or less in thickness exhibits a brittle failure under specified impact conditions. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. Note 1—This test method was developed jointly with the Society of the Plastics Industry, primarily for use with plasticized vinyl sheetings. Its applicability to other plastic sheetings must be verified by the user. 1.3 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 2—This test method and ISO 8570 address the same subject matter, but differ in technical content. |
||||||||||||
2. Referenced Documents | ||||||||||||
|
Poslední aktualizace: 22.11.2024 (Počet položek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.