Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM D1780-05(2020)
Standard Practice for Conducting Creep Tests of Metal-to-Metal Adhesives
Přeložit název
NORMA vydána dne 15.12.2020
Informace o normě:
Označení normy: ASTM D1780-05(2020)
Datum vydání normy: 15.12.2020
Kód zboží: NS-1013050
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM D1780-05(2020) :
Keywords:
creep, failure, load, recovery, strain, stress,, ICS Number Code 83.180 (Adhesives)
Doplňující informace
| Significance and Use | ||||
|
4.1?This practice provides information on the creep of bonded metal parts subjected to combined effects of temperature, shear, and time. |
||||
| 1. Scope | ||||
|
1.1?This practice covers the determination of the amount of creep of metal-to-metal adhesive bonds due to the combined effects of temperature, tensile shear stress, and time. Note 1:?Since the characteristics that render a material
resistant to creep under the condition of test are not yet
completely known, the details of the procedure considered herein
are those known to have important influences. Since other equally
important characteristics may be discovered in the future, the
recommended details are largely advisory in nature.
1.2?Test periods depend upon the reasonable life expected from the material in service. The uncertainties of extrapolation should be considered in deciding upon the length of the test. 1.3?The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.4?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||
| 2. Referenced Documents | ||||
|
Odebírejte informace o nově vydaných normách ZDARMA:
Chcete pravidelně odebírat informace o nově vycházejících normách z celého světa a to zcela zdarma?
Přihlašte se k odběru. Vše je velice jednoduché a absolutně ZDARMA.
Na výběr máte vydavatele z celého světa.
