Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Vicat Softening Temperature of Plastics
Automaticky přeložený název:
Standardní zkušební metoda pro Vicat měknutí Teplota plastů
NORMA vydána dne 15.11.2009
Označení normy: ASTM D1525-09
Poznámka: NEPLATNÁ
Datum vydání normy: 15.11.2009
Kód zboží: NS-17562
Počet stran: 10
Přibližná hmotnost: 30 g (0.07 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
plastics, thermoplastics, Vicat softening temperature, Softening temperature, Temperature tests--plastics, Thermoplastics, Vicat softening temperature (VST), ICS Number Code 83.080.01 (Plastics in general)
Significance and Use | ||||||||||||||||||
Data obtained by this test method is used to compare the heat-softening qualities of thermoplastic materials. This test method is useful in the areas of quality control, development, and characterization of plastic materials. |
||||||||||||||||||
1. Scope | ||||||||||||||||||
1.1 This test method covers determination of the temperature at which a specified needle penetration occurs when specimens are subjected to specified controlled test conditions. 1.2 This test method is not recommended for ethyl cellulose, nonrigid poly(vinyl chloride), poly(vinylidene chloride), or other materials having a wide Vicat softening range. 1.3 The values stated in SI units are to be regarded as standard. 1.4 Due to the potential safety and environmental hazards associated with mercury-filled thermometers, the use of alternative temperature measuring devices (such as thermocouples and RTDs) is encouraged. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1—This test method is equivalent to ISO 306 in all sections with the exceptions of the allowance for creep, prior to the beginning of the test and the allowance of the fluidized powder as a heat transfer medium. |
||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||
|
Historická
15.7.2013
Historická
15.11.2012
Historická
1.4.2010
Historická
15.12.2012
Historická
1.10.2010
Historická
1.12.2011
Poslední aktualizace: 21.11.2024 (Počet položek: 2 206 478)
© Copyright 2024 NORMSERVIS s.r.o.