Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Density of Plastics by the Density-Gradient Technique
Přeložit název
NORMA vydána dne 1.4.2018
Označení normy: ASTM D1505-18
Datum vydání normy: 1.4.2018
Kód zboží: NS-847247
Počet stran: 7
Přibližná hmotnost: 21 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
density, film, gradient, plaque, polyolefins, polyethylene, polypropylene, preparation,, ICS Number Code 83.080.01 (Plastics in general)
Significance and Use | ||||||||||
4.1 The density of a solid is a conveniently measurable property which is frequently useful as a means of following physical changes in a sample, as an indication of uniformity among samples, and a means of identification. 4.2 This test method is designed to yield results accurate to better than 0.05 %. Note 3: Where accuracy of 0.05 % or better is desired, the
gradient tube shall be constructed so that vertical distances of 1
mm shall represent density differences no greater than 0.0001
g/cm.3 The sensitivity of the column is then 0.0001
g/cm3·mm. Where less accuracy is needed, the gradient
tube shall be constructed to any required sensitivity.
|
||||||||||
1. Scope | ||||||||||
1.1 This test method covers the determination of the density of solid plastics. 1.2 This test method is based on observing the level to which a test specimen sinks in a liquid column exhibiting a density gradient, in comparison with standards of known density. Note 1: This test method is equivalent to
ISO 1183-2.
1.3 The values stated in SI units are to be regarded as the standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||
2. Referenced Documents | ||||||||||
|
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 21.12.2024 (Počet položek: 2 216 840)
© Copyright 2024 NORMSERVIS s.r.o.