Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Methods for Analysis of Lubricating Grease
Přeložit název
NORMA vydána dne 1.7.2019
Označení normy: ASTM D128-98(2019)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.7.2019
Kód zboží: NS-955601
Počet stran: 11
Přibližná hmotnost: 33 g (0.07 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
analysis, extraction, fat content, fluid content, free alkali content, free fatty acid content, glycerin content, insolubles content, lubricating grease, petroleum oil content, soap content, Soxhlet apparatus, thickener content, water content ,, ICS Number Code 75.100 (Lubricants, industrial oils and related products)
Significance and Use | ||||||||||||||||||
4.1 These test methods can be used to identify and estimate the amount of some of the constituents of lubricating greases. These test methods are applicable to many, but not all, greases. 4.2 Composition should not be considered as having any direct bearing on service performance unless such correlation is established. Note 2: Details on other test methods for grease analysis can
be found in other reference material.4,5,6
|
||||||||||||||||||
1. Scope | ||||||||||||||||||
1.1 These test methods for analysis cover greases of the conventional type, which consist essentially of petroleum oil and soap. The constituents that can be determined are soap, unsaponifiable matter (petroleum oil, and so forth), water, free alkalinity, free fatty acid, fat, glycerin, and insolubles. Note 1: Any of the test methods described herein are best used
by an experienced grease analyst who may also be able to make
appropriate adaptations of the techniques as occasion
requires.
1.2 A supplementary test method is provided in Appendix X1. This test method is intended primarily for application to greases containing thickeners that are essentially insoluble in 1.3 These test methods appear in the following order:
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||
|
Chcete mít jistotu o platnosti užívaných předpisů?
Nabízíme Vám řešení, abyste mohli používat stále platné (aktuální) legislativní předpisy.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 22.12.2024 (Počet položek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.