Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Drop Melting Point of Petroleum Wax, Including Petrolatum
Přeložit název
NORMA vydána dne 1.11.2019
Označení normy: ASTM D127-19
Datum vydání normy: 1.11.2019
Kód zboží: NS-983399
Počet stran: 10
Přibližná hmotnost: 30 g (0.07 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
drop melting point, petrolatum, petroleum wax, wax ,, ICS Number Code 75.140 (Waxes, bituminous materials and other petroleum products)
Significance and Use | ||||||
5.1 Melting point is a wax property that is of interest to most wax consumers. It can be an indication of the performance properties of the wax. Drop melting point, Test Method D127, is often used to measure the melting characteristics of petrolatums and other high viscosity petroleum waxes. |
||||||
1. Scope | ||||||
1.1 This test method covers the determination of the drop melting point of petroleum wax. It is used primarily for petrolatums and other microcrystalline wax. Note 1: Additional methods used for petroleum waxes are Test
Method D87 and Test Method
D938. Results obtained may
differ, depending on the method used. For pharmaceutical
petrolatum, Test Method D127
usually is used.
1.1.1 Test Method A—The dropping point of wax is determined with a mercury in glass thermometer, as stated below in6.3. (1.1.2 Test Method B—The dropping point of wax determined in a dropping point cup in an instrument which detects the drop and measures the temperature electronically, with a platinum thermometer instead of with mercury. Mercury has been recognized as a poison and a health hazard. Removing mercury from laboratories is a way of making the measuring process more inherently safe. The instrumental dropping point method has shown to produce results that are close to those determined by the original Test Method D127, Method A. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||
2. Referenced Documents | ||||||
|
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 01.11.2024 (Počet položek: 2 208 817)
© Copyright 2024 NORMSERVIS s.r.o.