Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Gauge Vapor Pressure of Liquefied Petroleum (LP) Gases (LP-Gas Method)
Přeložit název
NORMA vydána dne 1.3.2023
Označení normy: ASTM D1267-23
Datum vydání normy: 1.3.2023
Kód zboží: NS-1103701
Počet stran: 6
Přibližná hmotnost: 18 g (0.04 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
liquefied petroleum gases, natural gas liquids, vapor pressure ,, ICS Number Code 75.160.30 (Gaseous fuels)
Significance and Use | ||||
5.1?Information on the vapor pressures of liquefied petroleum gas products under temperature conditions from 37.8 ?C to 70 ?C (100 ?F to 158 ?F) is pertinent to selection of properly designed storage vessels, shipping containers, and customer utilization equipment to ensure safe handling of these products. 5.2?Determination of the vapor pressure of liquefied petroleum gas is important for safety reasons to ensure that the maximum operating design pressures of storage, handling, and fuel systems will not be exceeded under normal operating temperature conditions. 5.3?For liquefied petroleum gases, vapor pressure can be considered a semi-quantitative measure of the amount of the most volatile material present in the product, and this can give an indication of low temperature operability. |
||||
1. Scope | ||||
1.1?This test method covers the determination of the gauge vapor pressures of liquefied petroleum gas products at temperatures of 37.8 ?C (100 ?F) up to and including a test temperature of 70 ?C (158 ?F). (WarningExtremely flammable gas. May be harmful when inhaled.) Note 1:?An alternative method for measurement of vapor
pressure of liquefied petroleum gases is Test Method D6897.
1.2?The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard. 1.3?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||
2. Referenced Documents | ||||
|
Poslední aktualizace: 04.11.2024 (Počet položek: 2 209 323)
© Copyright 2024 NORMSERVIS s.r.o.