Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Kauri-Butanol Value of Hydrocarbon Solvents
Přeložit název
NORMA vydána dne 1.7.2021
Označení normy: ASTM D1133-13(2021)
Datum vydání normy: 1.7.2021
Kód zboží: NS-1031746
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
kauri-butanol value, hydrocarbon solvents, solvency power,, ICS Number Code 71.080.60 (Alcohols. Ethers),87.060.30 (Solvents)
Significance and Use | ||||||||||
4.1?The kauri-butanol value is used as a measure of solvent power of hydrocarbon solvents. High kauri-butanol values indicate relatively strong solvency. |
||||||||||
1. Scope | ||||||||||
1.1?This test method covers the determination of the relative solvent power of hydrocarbon solvents used in paint and lacquer formulations. This test method is suitable for use with solvents having an initial boiling point over 40 ?C and a dry point under 300 ?C when determined in accordance with the procedures in Note 1. Note 1:?Test Method D86
is used to determine the initial boiling point and dry point for
mineral spirits and similar petroleum solvents. Test Method
D1078 is used for pure
compounds and narrow boiling range cuts.
1.2?For purposes of determining conformance of an observed or a calculated value using this test method to relevant specifications, test result(s) shall be rounded off to the nearest unit in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29. 1.3?For specific hazard information and guidance, consult the supplier's Material Safety Data Sheet. 1.4?The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||
2. Referenced Documents | ||||||||||
|
Poslední aktualizace: 01.11.2024 (Počet položek: 2 208 817)
© Copyright 2024 NORMSERVIS s.r.o.