Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM C899-79(2018)
Standard Practice for Use of Metric Units of Measure for Reporting Properties of Refractory Materials
Přeložit název
NORMA vydána dne 1.10.2018
Informace o normě:
Označení normy: ASTM C899-79(2018)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.10.2018
Kód zboží: NS-900404
Počet stran: 2
Přibližná hmotnost: 6 g (0.01 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM C899-79(2018) :
Keywords:
metric, practice, properties, refractory,, ICS Number Code 01.060 (Quantities and units),81.080 (Refractories)
Doplňující informace
| Significance and Use | |||||||||||||||||||||||||||||||||
|
3.1 This practice is provided to facilitate comparison of physical and mechanical properties of refractory materials by establishing uniform presentation of data. 3.2 Units have been chosen, where possible, to result in numbers of magnitude familiar in the refractories industry, that is, g/cm3 rather than the SI preferred unit kg/m3. It is recommended that SI prefixes be selected for use with the units such that the resulting numerical values lie between 0.1 and 1000. For most properties, the prefixes kilo (k) and mega (M) are preferred. Other prefixes are given in the following table:
3.3 The conversion factors, which have
been selected for their general utility in the refractories
industry, have been taken from Practice E380, where possible. For uniformity,
they have been presented to four decimal places. In use, the
converted values should be rounded to the same number of
significant figures as in the original value.
|
|||||||||||||||||||||||||||||||||
| 1. Scope | |||||||||||||||||||||||||||||||||
|
1.1 This practice presents the units to be employed for reporting the properties of refractories, such as density, crushing stress, modulus of rupture, tensile stress, thermal conductivity, and permeability. 1.2 For convenience, a table of conversion factors between inch-pound units and SI units is included. 1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
|||||||||||||||||||||||||||||||||
| 2. Referenced Documents | |||||||||||||||||||||||||||||||||
|
Doporučujeme:
