Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Epoxy-Resin-Base Bonding Systems for Concrete
Automaticky přeložený název:
Standardní specifikace pro epoxidové pryskyřice -BASE systémy pro spojení na beton
NORMA vydána dne 1.12.2013
Označení normy: ASTM C881/C881M-13
Poznámka: NEPLATNÁ
Datum vydání normy: 1.12.2013
Kód zboží: NS-15446
Počet stran: 6
Přibližná hmotnost: 18 g (0.04 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
bonding, bonding systems, contact strength, contact time, epoxy resin, ICS Number Code 91.100.30 (Concrete and concrete products)
1. Scope | ||||||||||||||||
1.1 This specification covers two-component, epoxy-resin bonding systems for application to portland-cement concrete, which are able to cure under humid conditions and bond to damp surfaces. 1.2 This specification does not cover epoxy-resin-base bonding systems that have been modified by addition of components such as cement, fine aggregate, or fiber reinforcement. Additional testing may be required to meet applicable specifications for these applications. 1.3 This specification does not address the effects of creep on epoxy-resin-base bonding systems while under load or the potential for creep rupture. Additional testing is required for applications where creep and creep rupture are critical. 1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Some values have only SI units because the inch-pound equivalents are not used in practice. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with this standard. 1.5 This standard does not
purport to address all of the safety concerns, if any, associated
with its use. It is the responsibility of the user of this standard
to establish appropriate safety and health practices and determine
the applicability of regulatory limitations prior to use.
Standard Test Method for Thermal
Compatibility Between Concrete and an Epoxy-Resin Overlay Standard Test Method for Water Absorption
of Plastics Standard Test Method for Tensile
Properties of Plastics Standard Test Method for Deflection
Temperature of Plastics Under Flexural Load in the Edgewise
Position Standard Test Method for Compressive
Properties of Rigid Plastics Standard Test Method for Apparent
Viscosity of Adhesives Having Shear-Rate-Dependent Flow Properties
Using Rotational Viscometry Test Method for Linear Shrinkage of Cured
Thermosetting Casting Resins During Cure Standard Test Method for Bond Strength of
Epoxy-Resin Systems Used With Concrete By Slant Shear |
Poskytování aktuálních informací o legislativních předpisech vyhlášených ve Sbírce zákonů od roku 1945.
Aktualizace 2x v měsíci !
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 22.12.2024 (Počet položek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.