Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Dense Elastomeric Compression Seal Gaskets, Setting Blocks, and Spacers
Automaticky přeložený název:
Standard Specification pro hustou Kaučukovitý tlakové těsnění těsnění, Nastavení bloky, a distanční sloupky
NORMA vydána dne 1.6.2011
Označení normy: ASTM C864-05(2011)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.6.2011
Kód zboží: NS-15359
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
compression, dense, elastomer, elastomeric, gasket, glazing, preformed, seal, setting block, spacers, Spacers, Compression seals--specifications, Dense elastomeric gaskets, Elastomeric seals/sealants--specifications, Fire testing--gaskets, Flammability--gaskets, Gaskets--specifications, Glazing compounds/applications--specifications, Preformed elastomeric gaskets, Sealants--specifications, Setting blocks, ICS Number Code 91.100.50 (Binders. Sealing materials)
Significance and Use | ||||||||||||||||||||||||
Flame Propagation: This specification has two options: Option I—Flame propagation test is required. Option II—Flame propagation test is not required. In case no option is specified, Option I will apply. |
||||||||||||||||||||||||
1. Scope | ||||||||||||||||||||||||
1.1 This specification covers preformed dense elastomeric compression gaskets and accessories for use in sealing and glazing applications. These materials are generally used to seal or serve as components of compression sealing systems between mechanically restrained surfaces in building constructions. 1.2 Test Method C1166, as referenced in this specification, should be used to measure and describe the properties of materials, products, or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire risk assessment which takes into account all of the factors which are pertinent to an assessment of the fire hazard of a particular end use. 1.3 The following precautionary statement pertains only to the test method portion, Section 9, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.4 The committee with jurisdiction over this standard is not aware of any comparable standards published by other organizations. |
||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||
|
Poslední aktualizace: 22.12.2024 (Počet položek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.