Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Informace o normě:
Označení normy: ASTM C778-21
Datum vydání normy: 1.12.2021
Kód zboží: NS-1045122
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM C778-21 :
This specification covers standard sand for use in the testing of hydraulic cements. Sand shall meet the requirements with respect to grading, source of sand, and absence of undesirable air entraining characteristics. Sieve analysis shall be performed by sieving the sand by hand or mechanically as prescribed. Results of the sieve analysis shall be reported as total percentage passing each sieve. Small amounts of some surfactants or other contaminants will produce air voids in mortars with 20-30 sand, graded sands or both. Tests for air-entraining potential of standard sand shall be made on a single day by a single operator.
Keywords:
20-30 sand, graded sand, hydraulic cement testing sand, standard sand,, ICS Number Code 91.100.15 (Mineral materials and products)
Doplňující informace
| 1. Scope | ||||||||||||||||||||
|
1.1?This specification covers standard sand for use in the testing of hydraulic cements. 1.2?The values stated in SI units are to be regarded as the standard. 1.3?Values in SI units shall be obtained by measurement in SI units or by appropriate conversion, using the Rules for Conversion and Rounding given in IEEE/ASTM SI 10, of measurements made in other units. 1.4?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||
|
Doporučujeme:
Aktualizace technických norem
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
