Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM C661-06(2011)
Standard Test Method for Indentation Hardness of Elastomeric-Type Sealants by Means of a Durometer
Automaticky přeložený název:
Standardní zkušební metoda pro odsazení Tvrdost elastomerových typu, tmely pomocí durometer
NORMA vydána dne 1.1.2011
Informace o normě:
Označení normy: ASTM C661-06(2011)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.1.2011
Kód zboží: NS-14495
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Anotace textu normy ASTM C661-06(2011) :
Keywords:
elastomeric sealant, hardness, Durometer hardness, Hardness (indentation), Joint seals/sealants, ICS Number Code 83.060 (Rubber), 91.100.50 (Binders. Sealing materials)
Doplňující informace
| Significance and Use | ||||
|
The results obtained by this test method are simply a measure of the indentation into the sealant material of the indentor under load; they are not generally considered a measure of abrasion or wear resistance of the sealant. |
||||
| 1. Scope | ||||
|
1.1 This test method describes a laboratory procedure for determining indentation hardness of joint sealing compounds, (single- and multicomponent), intended for use in building construction. 1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only. 1.3 The committee with jurisdiction over this standard is not aware of any comparable standards published by other organizations. 1.4 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||
| 2. Referenced Documents | ||||
|
Doporučujeme:
