Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM C612-04e1
Standard Specification for Mineral Fiber Block and Board Thermal Insulation (Includes all amendments And changes 12/31/2010).
Automaticky přeložený název:
Standardní specifikace pro minerálních vláken Block a Board tepelnou izolací
NORMA vydána dne 1.5.2004
Informace o normě:
Označení normy: ASTM C612-04e1
Poznámka: NEPLATNÁ
Datum vydání normy: 1.5.2004
Kód zboží: NS-14252
Počet stran: 5
Přibližná hmotnost: 15 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Anotace textu normy ASTM C612-04e1 :
Keywords:
block, board, high temperature, mineral fiber insulation, rock fiber, shot, shot content, slag fiber, Block and board thermal insulation, ICS Number Code 91.100.60 (Thermal and sound insulating materials)
Doplňující informace
| 1. Scope | ||||||||||||||||||||||||||||||||||||||||||||||||||
|
1.1 This specification covers the classification, composition, dimension, and physical properties of mineral fiber (rock, slag, or glass) semi-rigid and rigid board insulation for the use on 0°F (-18°C) cooled surfaces and on heated surfaces up to 1800°F (982°C). Specific applications outside the maximum and minimum temperature limits shall be agreed upon between the supplier and the purchaser. 1.2 For satisfactory performance, properly installed protective vapor retarder or barriers shall be used on below ambient temperature applications to reduce movement of moisture through or around the insulation to the colder surface. Failure to use a vapor barrier can lead to insulation and system damage. Refer to Practice C 921 to aid material selection. Although vapor retarder properties are not part of this specification, properties required in Specification C 1136 are pertinent to applications or performance. 1.3 The orientation of the fibers within the boards is primarily parallel to the principal surface (face). This specification does not cover fabricated pipe and tank wrap insulation where the insulation has been cut and fabricated to provide a fiber orientation that is perpendicular to the principal large surface (face). 1.4 This standard does not purport to provide the performance requirements of hourly-rated fire systems. Consult the manufacturer for the appropriate system. 1.5 The values stated in inch-pound units shall be regarded as the standard. The SI equivalents of inch-pound units are given in parentheses for information only and are approximate. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||||||||||||||
|
Doporučujeme:
