Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM C206-14(2022)
Standard Specification for Finishing Hydrated Lime
Přeložit název
NORMA vydána dne 1.7.2022
Informace o normě:
Označení normy: ASTM C206-14(2022)
Datum vydání normy: 1.7.2022
Kód zboží: NS-1066972
Počet stran: 2
Přibližná hmotnost: 6 g (0.01 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM C206-14(2022) :
This specification covers two types of finishing hydrated lime that are suitable for use in the scratch, brown, and finish coats of plaster, for stucco, for mortar, and as an addition to Portland-cement concrete. The two types of lime are Type N and Type S. Finishing hydrated lime shall show no pops or pits. Chemical composition shall conform to the required contents of calcium and magnesium oxides, carbon dioxide, and unhydrated oxides. The plasticity figure for the lime is specified. The following test methods shall be performed: chemical analysis and physical tests.
Keywords:
finishing lime, masonry, plaster, plasticity, popping and pitting, residue, Type N, Type S, unhydrated oxides ,, ICS Number Code 91.100.10 (Cement. Gypsum. Lime. Mortar)
Doplňující informace
| 1. Scope | ||||||||||||||||
|
1.1?This specification covers two types of finishing hydrated lime that are suitable for use in the scratch, brown, and finish coats of plaster, for stucco, for mortar, and as an addition to portland-cement concrete. The two types of lime sold under this specification shall be designated as follows: 1.1.1?Type NNormal hydrated lime for finishing purposes, and 1.1.2?Type SSpecial hydrated lime for finishing purposes. Note 1:?Type N, normal finishing hydrated lime, is
differentiated from Type S, special finishing hydrated lime, in
that no limitation on the amount of unhydrated oxides is specified
for Type N hydrate, and the plasticity requirement for Type N
hydrate shall be determined after soaking for 16 to 24
h.
Note 2:?For lime putty, refer to Specification C1489.
1.2?The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||
|
Doporučujeme:
