Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Methods for Conducting Strength Tests of Masonry Wall Panels
Přeložit název
NORMA vydána dne 1.5.2019
Označení normy: ASTM C1717-19
Datum vydání normy: 1.5.2019
Kód zboží: NS-951290
Počet stran: 7
Přibližná hmotnost: 21 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
axial load, compressive load, concentrated loads, deformation, masonry, shear load, strength tests, transverse load, walls,, ICS Number Code 91.060.10 (Walls. Partitions. Facades)
Significance and Use | ||||
4.1 The test methods described in this standard are intended for use as a starting point in developing specific testing protocols for masonry elements. 4.1.1 The testing protocols could be used for general research on the load-deflection behavior of masonry elements. 4.1.2 The testing protocols could be used for qualification of masonry elements and materials by evaluation services and other parties. 4.1.3 The test methods described in this standard are general, and are intended to be adaptable to address a wide range of anticipated support and loading conditions. 4.2 How the test results are interpreted will depend on the intended use of the masonry element being tested. |
||||
1. Scope | ||||
1.1 These test methods cover methods for determining the strength and load-deflection characteristics of masonry wall elements. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||
2. Referenced Documents | ||||
|
Chcete mít jistotu o platnosti užívaných předpisů?
Nabízíme Vám řešení, abyste mohli používat stále platné (aktuální) legislativní předpisy.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 01.11.2024 (Počet položek: 2 208 817)
© Copyright 2024 NORMSERVIS s.r.o.