Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Infiltration Rate of In Place Pervious Concrete
Automaticky přeložený název:
Standardní zkušební metoda pro Infiltrace rychlost in Place propustná Beton
NORMA vydána dne 1.8.2009
Označení normy: ASTM C1701/C1701M-09
Poznámka: NEPLATNÁ
Datum vydání normy: 1.8.2009
Kód zboží: NS-12249
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
concrete, infiltration, pervious, water, ICS Number Code 91.100.30 (Concrete and concrete products)
Significance and Use | ||||||
Tests performed at the same location across a span of years may be used to detect a reduction of infiltration rate of the pervious concrete, thereby identifying the need for remediation. The infiltration rate obtained by this method is valid only for the localized area of the pavement where the test is conducted. To determine the infiltration rate of the entire pervious pavement multiple locations must be tested and the results averaged. The field infiltration rate is typically established by the design engineer of record and is a function of the design precipitation event. This test method does not measure the influence on in-place infiltration rate due to sealing of voids near the bottom of the pervious concrete slab. Visual inspection of concrete cores is the best approach for determining sealing of voids near the bottom of the pervious concrete slab. |
||||||
1. Scope | ||||||
1.1 This test method covers the determination of the field water infiltration rate of in place pervious concrete. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.4 The text of this standard references notes that provide explanatory material. These notes shall not be considered as requirements of the standard. |
||||||
2. Referenced Documents | ||||||
|
Historická
15.12.2009
Historická
15.11.2012
Historická
15.12.2012
Historická
1.6.2014
Historická
1.6.2014
Historická
1.10.2009
Poslední aktualizace: 22.12.2024 (Počet položek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.