Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Extruded Preformed Flexible Cellular Polyolefin Thermal Insulation in Sheet and Tubular Form
Přeložit název
NORMA vydána dne 1.3.2021
Označení normy: ASTM C1427-21
Datum vydání normy: 1.3.2021
Kód zboží: NS-1020815
Počet stran: 6
Přibližná hmotnost: 18 g (0.04 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
This specification covers the standard for two grades of extruded preformed flexible cellular polyolefin thermal insulation. Physical properties of preformed flexible cellular polyofelin thermal insulation which are mandatory for thermal design are also covered. Properties such as density and coefficient of thermal expansion (CTE) have been deemed nonmandatory for thermal design. The thermal insulation shall comply with physical requirements. Such physical requirements include thermal conductivity, water vapor permeability, and linear shrinkage and shall be determined by test methods specified here.
Keywords:
flexible thermal insulation, polyethylene foam, polyolefin foam, polyolefin thermal insulation, preformed thermal insulation, thermal insulating materials - pipe, thermal insulating materials - sheet,, ICS Number Code 27.220 (Heat recovery. Thermal insulation)
1. Scope | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||
1.1 This specification covers extruded preformed flexible cellular polyolefin thermal insulation operating temperatures from 150?F to 200?F (101?C to 93?C). For specific applications, the actual temperature limit shall be agreed upon between the manufacturer and the purchaser. 1.2?The use of thermal insulation materials covered by this specification are governed by codes and standards that address fire performance. Contact manufacturer for specific performance of product at the intended use thickness. 1.3?This specification covers the physical properties of preformed flexible cellular polyolefin thermal insulation, which have been deemed mandatory for thermal design. Physical properties such as density and coefficient of thermal expansion (CTE) have been deemed nonmandatory for thermal design. Nonmandatory physical properties have been included in Appendix X1 for information purposes only. 1.4?The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.5?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
Poslední aktualizace: 22.11.2024 (Počet položek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.