Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Pyrolytic and Vacuum Deposition Coatings on Flat Glass (Includes all amendments and changes 11/10/2021).
Přeložit název
NORMA vydána dne 1.9.2021
Označení normy: ASTM C1376-21a
Datum vydání normy: 1.9.2021
Kód zboží: NS-1041941
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
This specification covers the optical and aesthetic quality requirements for coatings applied to glass for use in building glazing. The coatings covered are applied to the glass using either pyrolytic or vacuum (sputtering) deposition methods and are typically applied to control solar heat gain, energy performance, comfort level, and condensation and enhance the aesthetic of the building. This specification groups coated glass according to application. These groups are: vision, spandrel/nonvision, and overhead. Coated flat glass furnished under this specification shall be of the following kinds: Kind CV; Kind CO; and Kind CS.
Keywords:
coated glass, color nonuniformity, flat glass, glazing, overhead glass, pyrolytic coating, spandrel glass, sputtered coatings, vacuum deposition coating, vision glass,, ICS Number Code 81.040.20 (Glass in building)
1. Scope | ||||||||
1.1?This specification covers the optical and aesthetic quality requirements for pyrolytic and vacuum deposition coatings applied on flat glass for use in building glazing. 1.2?The coatings are applied on the glass using either pyrolytic or vacuum sputtering deposition methods to control solar heat gain, energy performance, comfort level, and condensation and to enhance the aesthetic of the building. 1.3?This specification addresses blemishes related to the coating only. It does not address glass blemishes, applied ceramic frits to spandrel glass, and organic film opacifiers. 1.4?The 1.5?The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.6?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||
2. Referenced Documents | ||||||||
|
Poslední aktualizace: 22.11.2024 (Počet položek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.