Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Solvent Release Sealants
Přeložit název
NORMA vydána dne 1.6.2022
Označení normy: ASTM C1311-22
Datum vydání normy: 1.6.2022
Kód zboží: NS-1065658
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
This specification describes the properties of one-component solvent release sealants for use in building construction. These sealants are generally formulated to withstand a specified maximum joint movement in extension and compression of the nominal joint width. The sealants shall be tested, and is expected to conform to the following physical properties: extrudability after aging, shore A hardness, indentation hardness, bubbling, adhesive and cohesive loss after cyclic movement, slump, stain index, tack-free time, and accelerated weathering (edge cracking, center cracking, adhesion loss, and color change).
Keywords:
accelerated weathering, application life, bubbling, extrusion rate, sealant, sealing compound (sealing material), slump, solvent-release sealant, staining, tack free ,, ICS Number Code 91.100.50 (Binders. Sealing materials)
Significance and Use | ||||||||||||||||||||||
6.1?This specification describes solvent release sealants for general caulking and sealing operations in building construction. However, it should be recognized by the user that not all sealants meeting this specification are suitable for all applications and all substrates and that there is no implication that the sealants are equivalent in all physical properties. 6.2?Refer to Guide C1193 for information on the proper use of sealants meeting this specification. |
||||||||||||||||||||||
1. Scope | ||||||||||||||||||||||
1.1?This specification describes the properties of a one-component solvent release sealant for use in building construction. These sealants are generally formulated to withstand a maximum joint movement of 7.5 % in extension and 7.5 % in compression of the nominal joint width. 1.2?The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.3?The committee with jurisdiction of this specification is not aware of any similar specification within ISO or any other organization. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||
|
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 21.11.2024 (Počet položek: 2 206 478)
© Copyright 2024 NORMSERVIS s.r.o.