Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Quantitatively Measuring the Effect of Thermal Shock and Thermal Cycling on Refractories
Automaticky přeložený název:
Standardní zkušební metoda pro kvantitativní měření Vliv tepelného šoku a tepelných cyklů na Refractories
NORMA vydána dne 1.3.2011
Označení normy: ASTM C1171-05(2011)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.3.2011
Kód zboží: NS-9828
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
modulus of rupture, refractories, sonic velocity, thermal cycling, Refractories (general), Modulus of rupture (MOR)--refractories, Quantitative analysis/measurement, Sonic velocity, Strength, Stress--refractories, Thermal cycling test, Thermal shock materials/testing, ICS Number Code 17.200.10 (Heat. Calorimetry), 81.080 (Refractories)
Significance and Use | ||||||||||
This test method indicates the ability of a refractory product to withstand the stress generated by sudden changes in temperature. Because the recommended furnace temperature of this cycling test is 1200°C (2190°F), this test method may not indicate the ability of a refractory product to withstand cycling at higher or lower temperatures, especially if the existing morphology of the refractory product changes. This test method is useful for research and development, as well as for comparing refractory products. The precision should be considered when using this test for specification purposes. |
||||||||||
1. Scope | ||||||||||
1.1 This test method is used for determining the strength loss or reduction in continuity, or both, of prism-shaped specimens which are cut from refractory brick or shapes and subjected to thermal cycling. 1.2 The strength loss is measured by the difference in modulus of rupture (MOR) between uncycled specimens and the specimens subjected to thermal cycling. 1.3 The reduction in structural continuity is estimated by the difference in sonic velocity before and after thermal cycling. 1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||
2. Referenced Documents | ||||||||||
|
Poslední aktualizace: 22.11.2024 (Počet položek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.