Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Methods for Oil Content, Oil-Impregnation Efficiency, and Surface-Connected Porosity of Sintered Powder Metallurgy (PM) Products Using Archimedes’ Principle
Přeložit název
NORMA vydána dne 1.9.2022
Označení normy: ASTM B963-22
Poznámka: NEPLATNÁ
Datum vydání normy: 1.9.2022
Kód zboží: NS-1083891
Počet stran: 6
Přibližná hmotnost: 18 g (0.04 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
impregnation efficiency, oil content, oil-impregnated bearings, oil-impregnation efficiency, oil-impregnated PM parts, surface-connected porosity,, ICS Number Code 77.160 (Powder metallurgy)
Significance and Use | ||||||||||
5.1?Oil content values are generally contained in specifications for oil-impregnated PM bearings. 5.2?The oil-impregnation efficiency provides an indication of how well the as-received parts had been impregnated. 5.3?The desired self-lubricating performance of PM bearings requires a minimum amount of surface-connected porosity and satisfactory oil impregnation of the surface-connected porosity. A minimum oil content is specified. 5.4?The results from these test methods may be used for quality control or compliance purposes. |
||||||||||
1. Scope | ||||||||||
1.1?This standard describes three related test methods that cover the measurement of physical properties of oil-impregnated powder metallurgy products. 1.1.1?Determination of the volume percent of oil contained in the material. 1.1.2?Determination of the efficiency of the oil-impregnation process. 1.1.3?Determination of the percent surface-connected porosity by oil impregnation. 1.2?UnitsWith the exception of the values for density and the mass used to determine density, for which the use of the gram per cubic centimetre (g/cm3) and gram (g) units is the long-standing industry practice, the values in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard. 1.3?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||
2. Referenced Documents | ||||||||||
|
Poslední aktualizace: 22.12.2024 (Počet položek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.