Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Practice for Color Codes on Zinc and Zinc Alloy Ingot for Use in Hot-Dip Galvanizing of Steel
Přeložit název
NORMA vydána dne 1.11.2021
Označení normy: ASTM B914-21
Datum vydání normy: 1.11.2021
Kód zboží: NS-1044481
Počet stran: 2
Přibližná hmotnost: 6 g (0.01 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
Alloy A-1, Alloy A-2, Alloy A-3, Alloy A-4, Alloy A-5, Alloy A-6, Alloy S-1, aluminum-zinc alloys, color, color code, GALFAN, GALVALUME, galvanizing, hot-dip, non-ferrous metals, Type 5, Type 10, Type 15, zinc, zinc alloys, zinc-aluminum alloys, Zn/Al,, ICS Number Code 77.150.99 (Other products of non-ferrous metals)
Significance and Use | ||||||||||||||||||
4.1?The purpose of these color codes is to allow for quick identification of ingot bundles or jumbo ingots of alloys used for hot-dip galvanizing. Other than jumbo ingots, this standard is not intended to imply that each ingot will be color-coded but only that each ingot bundle be color coded. 4.2?Each ingot bundle or jumbo ingot shall be identified with the appropriate color code listed in Table 1. 4.3?The
color will be applied as a stripe, or stripes, on two adjacent
sides of the ingot bundle or jumbo ingot. The color stripes will be
applied to include the ingot bundle foot.
4.4?When using multiple stripes, the colored stripes will be applied from left to right as indicated in Table 1. 4.5?In the absence of a written agreement to the contrary between the supplier and end user, the North American color code will be the standard for all North American transactions; for all other transactions the International Color Code will be used. |
||||||||||||||||||
1. Scope | ||||||||||||||||||
1.1?This standard is published with the following objectives: 1.1.1?To establish standard color codes for zinc, zinc alloy and zinc master alloy ingot used by the Hot-Dip Galvanizing industry, and 1.1.2?To standardize the use and application of these color codes. 1.2?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety, health, and environmental practices, and determine the applicability of regulatory limitations prior to use. 1.3?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||
|
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 21.11.2024 (Počet položek: 2 206 478)
© Copyright 2024 NORMSERVIS s.r.o.