Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Zinc Casting Alloy Ingot for Sheet Metal Forming Dies and Plastic Injection Molds
Přeložit název
NORMA vydána dne 1.5.2016
Označení normy: ASTM B793-16
Poznámka: NEPLATNÁ
Datum vydání normy: 1.5.2016
Kód zboží: NS-640221
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
blanking dies, casting, casting alloys, forming dies, gravity casting, Kirksite, Kirksite A, Kirksite B, sheet metal dies, zinc,, ICS Number Code 77.120.60 (Lead, zinc, tin and their alloys)
1. Scope | ||||||||||||||||||||
1.1 This specification covers commercial zinc alloys in ingot form for remelting for the manufacture of dies and molds from the alloys as shown in Table 1. 1.2 This specification presents
requirements for zinc alloys suitable for the production of sand
cast or plaster cast forming dies for sheet metal stamping
operations and plastic injection molding. Alloy A is intended for
use in the fabrication of dies for sheet metal stamping under drop
hammer and hydraulic pressure. Alloy B is a special purpose alloy
of closely controlled composition and is primarily used in the
manufacture of plastic injection molds.
1.3 This specification covers two zinc alloys which are specified and designated as follows:
1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||
|
Poslední aktualizace: 01.05.2024 (Počet položek: 2 896 514)
© Copyright 2024 NORMSERVIS s.r.o.