Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM B689-97(2018)
Standard Specification for Electroplated Engineering Nickel Coatings
Přeložit název
NORMA vydána dne 1.6.2018
Informace o normě:
Označení normy: ASTM B689-97(2018)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.6.2018
Kód zboží: NS-851174
Počet stran: 7
Přibližná hmotnost: 21 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM B689-97(2018) :
Keywords:
ICS Number Code 25.220.40 (Metallic coatings)
Doplňující informace
| 1. Scope | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
1.1 This specification covers the requirements for electroplated nickel coatings applied to metal products for engineering applications, for example, for use as a buildup for mismachined or worn parts, for electronic applications, including as underplates in contacts or interconnections, and in certain joining applications. 1.2 Electroplating of nickel for engineering applications (Note 1) requires technical considerations significantly different from decorative applications because the following functional properties are important: 1.2.1 Hardness, strength, and ductility, 1.2.2 Wear resistance, 1.2.3 Load bearing characteristics, 1.2.4 Corrosion resistance, 1.2.5 Heat scaling resistance, 1.2.6 Fretting resistance, and 1.2.7 Fatigue resistance. Note 1: Functional electroplated nickel coatings usually
contain about 99 % nickel, and are most frequently electrodeposited
from a Watts nickel bath or a nickel sulfamate bath. Typical
mechanical properties of nickel electroplated from these baths, and
the combined effect of bath operation and solution composition
variables on the mechanical properties of the electrodeposit are
given in Guide B832. When
electroplated nickel is required to have higher hardnesses, greater
wear resistance, certain residual stress values and certain
leveling characteristics, sulfur and other substances are
incorporated in the nickel deposit through the use of certain
addition agents in the electroplating solution. For the effect of
such additives, see Section 4
and Annex A3. Cobalt salts
are sometimes added to the plating solution to produce harder
nickel alloy deposits.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
Doporučujeme:
