Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Platinum-Iridium Electrical Contact Materials
Přeložit název
NORMA vydána dne 1.4.2022
Označení normy: ASTM B684/B684M-22
Datum vydání normy: 1.4.2022
Kód zboží: NS-1053945
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
This specification covers two platinum-iridium alloys in the form of rod, wire, strip, and sheet material for electrical contacts. Raw materials shall be of such quality and purity that the finished product (produced by cold working, annealing, turning, grinding, or pickling as required) will have the properties and characteristics prescribed in this specification. The alloys shall meet the requirements of chemical composition specified for platinum, iridium, total impurities, total platinum group (palladium, rhodium, osmium, ruthenium, and gold), total other impurities (including lead, antimony, bismuth, tin, arsenic, cadmium, zinc, and iron) and other elements. Ultimate tensile strength, elongation, microhardness (Knoop or Vickers), hardness (Rockwell or Rockwell Superficial), or a combination of these mechanical properties may be specified as criterion for temper designation. Annealed and work hardened wire and strip shall conform to the mechanical requirements prescribed for ultimate tensile strength, elongation, and microhardness. Knoop hardness test, tension test, and chemical analysis using spectrochemical or wet analysis method shall be performed.
Keywords:
electrical contact materials, iridium alloy, medical material, platinum alloy, platinum iridium alloys,, ICS Number Code 77.120.99 (Other non-ferrous metals and their alloys)
1. Scope | ||||||||||
1.1?This specification covers an 80 % platinum20 % iridium alloy, an 85 % platinum15 % iridium alloy, and a 90 % platinum10 % iridium alloy, in the form of rod, wire, strip, and sheet material for electrical contacts. 1.2?The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined. 1.3?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety, health, and environmental practices, and determine the applicability of regulatory limitations prior to use. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||
2. Referenced Documents | ||||||||||
|
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 12.09.2024 (Počet položek: 2 346 316)
© Copyright 2024 NORMSERVIS s.r.o.