Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Seal Quality of Anodic Coatings on Aluminum by Acid Dissolution
Automaticky přeložený název:
Standardní zkušební metoda pro Seal kvalitu anodických povlaků na hliníku kyselými Rozpuštění
NORMA vydána dne 15.4.2009
Označení normy: ASTM B680-80(2009)
Poznámka: NEPLATNÁ
Datum vydání normy: 15.4.2009
Kód zboží: NS-7693
Počet stran: 2
Přibližná hmotnost: 6 g (0.01 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
Acid dissolution test, Aluminum alloys (anodic coatings), Aluminum coatings, Anodic coatings--Al/Al alloys), Sealability, ICS Number Code 25.220.40 (Metallic coatings)
Significance and Use | ||||
This test method describes a destructive test procedure for measuring the degree of seal of the porosity in anodic oxide coatings. Low coating mass loss is an indication of good seal quality and of the ability of the coating to resist staining and “blooming” in many types of service. This test method is suitable for quality control purposes within manufacturing operations and for determining whether anodized parts meet seal quality requirements in applicable specifications. |
||||
1. Scope | ||||
D
1.1 This test method covers a test for the quality of seal of porous anodic coatings on aluminum and its alloys. It is based upon the loss in mass of the coating after immersion in a warm phosphoric-chromic acid solution. 1.2 This test method is applicable to anodic coatings intended for exposure to the weather, or for protective purposes in corrosive media, and where resistance to staining is important. 1.3 This test method is not applicable to: 1.3.1 Hard coatings, which normally are not sealed. 1.3.2 Anodic coatings that have been sealed only in dichromate solutions. 1.3.3 Anodic coatings that have undergone a treatment to render them hydrophobic. 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||
2. Referenced Documents | ||||
|
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 22.11.2024 (Počet položek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.