Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM B605-95a(2009)
Standard Specification for Electrodeposited Coatings of Tin-Nickel Alloy (Includes all amendments And changes 4/8/2015).
Automaticky přeložený název:
Standard Specification pro elektrolyticky vyloučené povlaky Tin-niklové slitiny
NORMA vydána dne 1.9.2009
Informace o normě:
Označení normy: ASTM B605-95a(2009)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.9.2009
Kód zboží: NS-7372
Počet stran: 6
Přibližná hmotnost: 18 g (0.04 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Anotace textu normy ASTM B605-95a(2009) :
Keywords:
alloys, electrodeposited, tin-nickel, coatings, electrodeposited, nickel alloy, coatings, electrodeposited, tin-nickel alloy, tin-nickel alloy, Burnishing test--for coating adhesion, Coating adhesion--electrodeposited coatings, Copper alloy electrodeposited coatings, Electrodeposited Sn coatings--specifications, Iron products (general)--electrodeposited coatings, Porosity--electrodeposited/metallic coatings, Steel--electrodeposited coatings, Sulfur dioxide (SO2)
Doplňující informace
| 1. Scope | ||||||||||||||||||||||||||||||||||||||||||||||
|
1.1 This specification covers the requirements for electrodeposited tin-nickel alloy coatings from aqueous solutions intended for the corrosion protection of fabricated articles of iron, steel, zinc-base alloys, copper, and copper alloys. The composition of the alloy remains constant at 65/35 tin-nickel in spite of wide fluctuations in both composition and operating conditions. The composition corresponds quite closely to an equiatomic ratio, and the process favors the co-deposition of tin and nickel atoms at identical rates. 1.2 This specification does not apply to sheet, strip, or wire in the fabricated form. It also may not be applicable to threaded articles having basic major diameters up to and including 19 mm because of the nonuniformity of thickness that can be expected on fine threads. However, a decision to use the coating on such components may be made by the purchaser. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||||||||||
|
Doporučujeme:
