Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM B566-04a(2021)
Standard Specification for Copper-Clad Aluminum Wire (Includes all amendments and changes 10/22/2021).
Přeložit název
NORMA vydána dne 1.10.2021
Informace o normě:
Označení normy: ASTM B566-04a(2021)
Datum vydání normy: 1.10.2021
Kód zboží: NS-1040589
Počet stran: 5
Přibližná hmotnost: 15 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM B566-04a(2021) :
This specification covers bare round copper-clad aluminum wire for electrical applications. Four classes of copper-clad aluminum wire are covered such as Class 10A, Class 15A, Class 10H, Class 15H. The wire shall consist of a core of aluminum with a continuous outer cladding of copper throughly bonded to the core throughout and shall be of such quality as to meet the requirements of this specification. The copper-clad aluminum wire shall conform to the tensile strength and elongation requirements. The electrical resistivity shall be measured. The copper-clad aluminum wire, when tested shall be free from seams or splits. They shall be free from cladding delamination. The finished wire shall contain no joints or splices. The density of the wire shall be taken for calculating mass/unit length, cross section and so forth.
Keywords:
aluminum electrical conductor—copper-clad, aluminum wire, aluminum wire—copper-clad, copper-clad aluminum wire, copper-clad electrical conductors, electrical conductor,, ICS Number Code 29.060.10 (Wires)
Doplňující informace
| 1. Scope | ||||||
|
1.1?This specification covers bare round copper-clad aluminum wire for electrical applications. 1.2?Four
classes of copper-clad aluminum wire are covered as follows: 1.3?The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3.1?ExceptionThe values stated in SI units for resistivity and density are to be regarded as standard. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||
| 2. Referenced Documents | ||||||
|
Doporučujeme:
Aktualizace technických norem
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
