Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Methods for Tension Testing Wrought and Cast Aluminum- and Magnesium-Alloy Products (Metric)
Automaticky přeložený název:
Standardní zkušební metody pro Tension testování spravil a Cast hliník- a slitiny hořčíku Products (metrické)
NORMA vydána dne 15.5.2014
Označení normy: ASTM B557M-14
Poznámka: NEPLATNÁ
Datum vydání normy: 15.5.2014
Kód zboží: NS-7165
Počet stran: 16
Přibližná hmotnost: 48 g (0.11 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
elongation, strain, stress, tensile strength, tensile testing, yield strength, ICS Number Code 77.040.10 (Mechanical testing of metals), 77.120.10 (Aluminium and aluminium alloys)
Significance and Use | ||||||||||||||||||
4.1 Tension tests provide information on the strength and ductility of materials under uniaxial tensile stresses. This information may be useful in comparisons of materials, alloy development, quality control, and design under certain circumstances. 4.2 The results of tension tests of specimens machined to standardized dimensions from selected portions of a part or material may not totally represent the strength and ductility properties of the entire end product or its in-service behavior in different environments. 4.3 These test methods are considered satisfactory for acceptance testing of commercial shipments and have been used extensively in the trade for this purpose. |
||||||||||||||||||
1. Scope | ||||||||||||||||||
1.1 These test methods cover the tension testing of wrought and cast aluminum- and magnesium-alloy products, excepting aluminum foil2, and are derived from Test Methods E8M, which cover the tension testing of all metallic materials. Note 1: These metric test methods are the equivalents of those
in Test Methods B557, and are
compatible in technical content except for the requirement of
longer gage lengths for round specimens.
Note 2: Exceptions to the provisions of these test methods may
need to be made in individual specifications or test methods for a
particular material.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||
|
Poslední aktualizace: 22.12.2024 (Počet položek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.