Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Silver-Coated, Copper-Clad Steel Wire for Electronic Application
Automaticky přeložený název:
Standardní specifikace pro Silver - Coated , měděné ocelovým drátem pro Elektronická přihláška
NORMA vydána dne 1.4.2015
Označení normy: ASTM B501-10(2015)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.4.2015
Kód zboží: NS-585770
Počet stran: 5
Přibližná hmotnost: 15 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
clad steel electrical conductor, copper-clad steel electrical conductor, electrical conductor, silver&mdash,electrical/electronic application, silver-coated, copper-clad steel wire,, ICS Number Code 29.060.10 (Wires)
1. Scope | ||||||
1.1 This specification covers silver-coated, round, copper-clad steel wire for electronic application. 1.2 Silver coatings in mass percentages of the total mass of the coated wire are as follows: 1.25, 2.5, 4.0, 6.1, and 8.0. 1.2.1 Silver-coated wire having different minimum percentage of silver by mass may be obtained by mutual agreement between the manufacturer and the purchaser. For information purposes, the thickness of coating in microinches provided by the mass percentages listed in 1.2 is shown in Table 1. 1.3 Four classes of copper-clad steel wire are covered as follows: Class 30HS nominal 30 % conductivity hard-drawn, Class 30A nominal 30 % conductivity annealed, Class 40HS nominal 40 % conductivity hard-drawn, and Class 40A nominal 40 % conductivity annealed. 1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4.1 Exception—In resistivity the SI units are to be regarded as the standard 1.5 The following safety hazards caveat pertains to
the test method described in this specification. This
standard does not purport to address all of the safety problems, if
any, associated with its use. It is the responsibility of the user
of this standard to establish appropriate safety and health
practices and determine the applicability of regulatory limitations
prior to use. (
Standard Specification for Copper-Clad
Steel Wire for Electronic Application Standard Specification for Standard
Nominal Diameters and Cross-Sectional Areas of AWG Sizes of Solid
Round Wires Used as Electrical Conductors Standard Test Method for Resistivity of
Electrical Conductor Materials |
Historická
1.2.2013
Historická
1.9.2014
Historická
1.4.2011
Historická
1.4.2014
Historická
1.10.2011
Historická
1.8.2011
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 25.03.2024 (Počet položek: 2 885 931)
© Copyright 2024 NORMSERVIS s.r.o.