Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Electrodeposited Coatings of Gold for Engineering Uses
Přeložit název
NORMA vydána dne 1.8.2018
Označení normy: ASTM B488-18
Datum vydání normy: 1.8.2018
Kód zboží: NS-904411
Počet stran: 8
Přibližná hmotnost: 24 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
This specification establishes the requirements for electrodeposited gold coatings for engineering applications, employed specifically for their corrosion and tarnish resistance (including resistance to fretting corrosion and catalytic polymerization), bondability, low and stable contact resistance, solderability, and infrared reflectivity. This specification does not cover gold coatings produced from autocatalytic, immersion, and vapor deposition. Coatings shall be classified into types, which characterize minimum purity, and codes, which designate Knoop hardness. Coatings shall be sampled, tested and conform to specified requirements as to purity, hardness, appearance, thickness, mass per unit area, ductility, adhesion (assessed by either bend, heat, or cutting test), and integrity (including gross defects, mechanical damage, and porosity).
Keywords:
engineering coatings, engineering gold, gold, gold coatings, gold electrodeposits, gold platings, underplate ,, ICS Number Code 25.220.40 (Metallic coatings)
1. Scope | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
1.1 This specification covers requirements for electrodeposited gold coatings that contain not less than 99.00 mass % gold and that are used for engineering applications. 1.2 Specifically excluded from this specification are autocatalytic, immersion, and vapor deposited gold coatings. 1.3 Gold coatings conforming to this specification are employed for their corrosion and tarnish resistance (including resistance to fretting corrosion and catalytic polymerization), bondability, low and stable contact resistance, solderability, and infrared reflectivity. Several types of coatings, differing in gold purity and hardness, are covered by this specification. 1.4 The values stated in SI units are to be regarded as the standard. Values provided in parentheses are for information only. 1.5 The following hazards caveat pertains only to the test methods section, Section 9, of this specification: 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
Poslední aktualizace: 22.12.2024 (Počet položek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.