Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Bonded Copper Conductors for Use in Hookup Wires for Electronic Equipment
Přeložit název
NORMA vydána dne 1.4.2017
Označení normy: ASTM B470-02(2017)
Datum vydání normy: 1.4.2017
Kód zboží: NS-681008
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
This specification covers stranded uninsulated bare, tin, or tin-lead alloy coated copper conductors in which wires in the strand are metallically bonded together by the application of heat additional tin, or tin-lead alloy for use in hookup wire for electronic equipment. Conductor constructions shall conform to standard ASTM requirements except that, in addition, the following bondings may be specified: Type I, Type II, and Type III. The conductors shall consist of tinned copper and bare copper, conforming to product description, quality, and specification requirements. The material shall undergo flex, fraying, mandrel, and resistance tests. The material shall meet the minimum flex life requirements and shall conform to the required conditions for flex, fraying, and madrel tests.
Keywords:
bonded copper conductors, copper conductor for electronic equipment, copper electrical conductor, electrical conductor, electrical conductor´copper,, ICS Number Code 29.060.10 (Wires)
1. Scope | ||||
1.1 This specification covers stranded uninsulated bare, tin, or tin-lead alloy coated copper conductors in which wires in the strand are metallically bonded together by the application of heat or additional tin, or tin-lead alloy for use in hookup wire for electronic equipment. 1.2 The SI values for density and resistivity are to be regarded as standard. For all other properties, the inch-pound values are to be regarded as the standard and the SI units may be approximate. 1.3 The hazard caveat pertains only to Section 6 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||
2. Referenced Documents | ||||
|
Chcete pravidelně odebírat informace o nově vycházejících normách z celého světa a to zcela zdarma?
Přihlašte se k odběru. Vše je velice jednoduché a absolutně ZDARMA.
Na výběr máte vydavatele z celého světa.
Poslední aktualizace: 25.03.2024 (Počet položek: 2 885 931)
© Copyright 2024 NORMSERVIS s.r.o.