Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM B398/B398M-22
Standard Specification for Aluminum-Alloy 6201-T81 and 6201-T83 Wire for Electrical Purposes
Přeložit název
NORMA vydána dne 1.12.2022
Informace o normě:
Označení normy: ASTM B398/B398M-22
Datum vydání normy: 1.12.2022
Kód zboží: NS-1100815
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM B398/B398M-22 :
This specification covers aluminum-alloy 6201-T81 round wire which are solution heat-treated, cold worked, and artificially aged for electrical purposes. The material shall conform to the chemical composition requirements. Tensile properties such as tensile strength and elongation and bending properties shall be determined via a tension test and bending test, respectively. The electrical resistivity and density of the wires shall be measured as well.
Keywords:
aluminum alloy 6201-T81 wire, aluminum alloy 6201-T83 wire, aluminum alloy wire, aluminum wire, electrical conductor-aluminum, electrical conductors,, ICS Number Code 29.060.10 (Wires)
Doplňující informace
| 1. Scope | ||||||||||||||||
|
1.1?This specification covers aluminum-alloy 6201-T81 (hard, solution heat-treated, cold worked, and artificially aged) and 6201-T83 (hard, higher conductivity, solution heat-treated, cold worked, and artificially aged) round wire for electrical purposes. Note 1:?The alloy and temper designations conform to ANSI
H35.1 and H35.1M. Aluminum-alloy 6201 corresponds to unified
numbering system alloy A96201 in accordance with Practice
E527.
1.2?The values stated in inch-pound or SI units are to be regarded separately as standard. The values in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. 1.2.1?For density, resistivity and temperature, the values stated in SI units are to be regarded as standard. 1.3?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||
|
Doporučujeme:
