Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Expansion (Pin Test) of Copper and Copper-Alloy Pipe and Tubing
Přeložit název
NORMA vydána dne 1.5.2022
Označení normy: ASTM B153-22
Datum vydání normy: 1.5.2022
Kód zboží: NS-1057582
Počet stran: 2
Přibližná hmotnost: 6 g (0.01 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
copper, copper alloy, expansion, expansion test, pin test, pipe, tube,, ICS Number Code 23.040.15 (Non-ferrous metal pipes)
Significance and Use | ||||
5.1?When properly performed and interpreted, the expansion pin test will provide information with regard to the capacity of a tube for expansion and to reveal surface defects. The expansion pin test may provide data for research and development, engineering design, quality control, and acceptance or rejections in specifications. 5.2?In certain product specifications which establish requirements for tubes of sizes greater than 4 in. (102 mm), the test described in Test Method B968/B968M may be allowed as a substitute. |
||||
1. Scope | ||||
1.1?This test method establishes the requirements for the expansion pin test for copper and copper-alloy pipe and tubing with an inside diameter of 0.125 in. (3.2 mm) and greater or an outside diameter up to and including 4 in. (102 mm). Note 1:?For tubes of sizes with an inside diameter less than
0.125 in. (3.2 mm), a substitute test method must be agreed upon
between the manufacturer and purchaser.
Note 2:?For tubes of sizes greater than 4 in. (102 mm) in
outside diameter, refer to B968/B968M for a test method.
1.2?UnitsThe values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||
2. Referenced Documents | ||||
|
Poslední aktualizace: 01.11.2024 (Počet položek: 2 208 817)
© Copyright 2024 NORMSERVIS s.r.o.