Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM B1007-17
Standard Specification for Welded Precipitation Hardenable or Cold Worked, Nickel Alloy Tube
Přeložit název
NORMA vydána dne 1.11.2017
Informace o normě:
Označení normy: ASTM B1007-17
Poznámka: NEPLATNÁ
Datum vydání normy: 1.11.2017
Kód zboží: NS-803746
Počet stran: 5
Přibližná hmotnost: 15 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM B1007-17 :
Keywords:
UNS N07725, UNS N07740, UNS N09945, UNS N09946, UNS N09925, UNS N07718, UNS N10276, UNS N06985, welded cold worked tube, welded precipitation hardened tube,, ICS Number Code 23.040.15 (Non-ferrous metal pipes)
Doplňující informace
| 1. Scope |
|
1.1 This specification covers nominal and minimum wall-thickness welded tubes and welded and cold worked tubes made from the nickel alloys listed in Table 1. Anticipated uses cover applications where strength and strength at elevated temperatures are desired attributes. Some examples are hydraulic control lines, boilers, heat exchangers, and solar absorbers. 1.2 Tube shall be supplied in one of the
following conditions; cold worked, cold worked and precipitation
hardened, solution annealed plus precipitation hardened, or
solution annealed and descaled conditions. When atmosphere control
is used, descaling is not necessary.
1.3 This specification covers tube 1/8 to 6 in. (3.2 to 152.4 mm) in outside diameter and 0.015 to 0.148 in. (0.41 to 3.7 mm) inclusive in wall thickness. 1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
Doporučujeme:
