Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM A980/A980M-19
Standard Specification for Steel, Sheet, Carbon, Ultra High Strength Cold Rolled
Přeložit název
NORMA vydána dne 1.9.2019
Informace o normě:
Označení normy: ASTM A980/A980M-19
Datum vydání normy: 1.9.2019
Kód zboží: NS-970838
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM A980/A980M-19 :
This specification covers the standard for cold rolled ultra high strength carbon steel sheet in coils or cut lengths. The sheet shall be produced from aluminum killed steel and shall undergo continuous annealing to austenitic temperatures and then be water quenched. Cast or heat analysis shall conform to the prescribed chemical composition requirements in carbon, manganese, phosphorus, sulfur, and aluminum. Tension test shall be done on the point immediately adjacent to the material to be tested and properties shall conform to the specified tensile strength. The sheet shall have a matte surface finish texture and shall have cut edges. Unless otherwise specified, the sheet shall undergo oiling.
Keywords:
carbon steel sheet, cold rolled steel sheet, steel sheet, ultra high-strength,, ICS Number Code 77.140.50 (Flat steel products and semi-products)
Doplňující informace
| 1. Scope | ||
|
1.1 This specification covers a cold rolled ultra high strength carbon steel sheet in coils or cut lengths. The product is available in five strength levels. The steel's strength is obtained by water quenching from an austenitic temperature resulting in a martensitic microstructure. This product is intended for miscellaneous applications where ultra high strength, weight saving, and good weldability are important. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||
| 2. Referenced Documents | ||
|
Doporučujeme:
EviZak - všechny zákony včetně jejich evidence na jednom místě
Poskytování aktuálních informací o legislativních předpisech vyhlášených ve Sbírce zákonů od roku 1945.
Aktualizace 2x v měsíci !
Chcete vědět více informací? Podívejte se na tuto stránku.
