Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Practice for Indentation Hardness of Metallic Materials by Comparison Hardness Testers (Includes all amendments And changes 10/20/2014).
Automaticky přeložený název:
Standardní praxe pro odsazení Tvrdost kovových materiálů ve srovnání tvrdoměrů
NORMA vydána dne 1.11.2008
Označení normy: ASTM A833-08a
Poznámka: NEPLATNÁ
Datum vydání normy: 1.11.2008
Kód zboží: NS-4435
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
Brinell hardness, comparative hardness, comparative hardness testers, metallic, Brinell hardness, Comparison techniques, Hardness (indentation)--metallic materials, Metallic hardness, ICS Number Code 77.040.10 (Mechanical testing of metals)
Significance and Use | ||||
The comparative hardness test is an empirical dynamic indentation hardness test. Comparative hardness tests provide useful information about metallic materials. This information may correlate to tensile strength, wear resistance, ductility, heat treatment condition, or other physical characteristics of metallic materials, and may be useful in quality control and selection of materials. Comparative hardness testing at a specific location on a part may not represent the physical characteristics of the whole part or end product. |
||||
1. Scope | ||||
1.1 This practice covers the determination of indentation hardness of metallic materials using comparison hardness testers. 1.2 This practice applies only to those comparison hardness testers, normally portable, that use comparative test bars that have been standardized according to Test Method E 10 as a basis for comparison. 1.3 Calibration of comparative test bars (rods), used for comparison to determine hardness numbers, is also covered by this practice. 1.4 The impression force used during comparison hardness testing is normally an impact load applied by striking a hammer on the appropriate areas as outlined in the manufacturer's instructions. 1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.6 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||
2. Referenced Documents | ||||
|
Poskytování aktuálních informací o legislativních předpisech vyhlášených ve Sbírce zákonů od roku 1945.
Aktualizace 2x v měsíci !
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 22.11.2024 (Počet položek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.