Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM A801-21
Standard Specification for Wrought Iron-Cobalt High Magnetic Saturation Alloys (UNS R30005 and K92650)
Přeložit název
NORMA vydána dne 1.2.2021
Informace o normě:
Označení normy: ASTM A801-21
Datum vydání normy: 1.2.2021
Kód zboží: NS-1018206
Počet stran: 6
Přibližná hmotnost: 18 g (0.04 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM A801-21 :
This specification covers wrought iron-cobalt high magnetic saturation alloys, UNS R30005 and UNS K92650, for use in magnetic components requiring high permeability or high magnetic saturation. It covers material supplied in form of forging billets, hot-rolled products cold-finished bars, and strip. The material shall conform to the chemical requirements prescribed in this specification. Chemical analysis shall be performed for carbon, nitrogen, sulfur, and oxygen contents. DC magnetic property,which is the magnetic flux density of the material, shall meet the requirements prescribed in each type of alloys.
Keywords:
core loss, iron-cobalt alloy, magnetic flux density, saturation flux density,, ICS Number Code 77.080.10 (Irons)
Doplňující informace
| 1. Scope | ||||||||||||
|
1.1?This specification covers two wrought iron-cobalt alloy types for use in magnetic components requiring high permeability at and above 1.5 T (15 kG) or high saturation flux density. The specific alloy types covered are:
1.1.1?This specification also covers material supplied by a producer in the form and physical condition suitable for fabrication into parts that will later be given final heat treatment to achieve the desired magnetic characteristics and, where required, mechanical properties. It covers material supplied in form of forging billets, hot-rolled products (that is, bar, plate, and strip), cold-finished bars, and cold-rolled strip. 1.2?This specification does not cover parts produced by casting or by powder metallurgical techniques. 1.3?The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to customary (cgs-emu and inch-pound) units which are provided for information only and are not considered standard. 1.3.1?There are selected values presented in two units, both of which are in acceptable SI units. These are differentiated by the word , or, as in g/cm3, or, (kg/m3). 1.4?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||
| 2. Referenced Documents | ||||||||||||
|
Doporučujeme:
