Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Welded, Unannealed Austenitic Stainless Steel Tubular Products
Přeložit název
NORMA vydána dne 1.5.2016
Označení normy: ASTM A778/A778M-16
Poznámka: NEPLATNÁ
Datum vydání normy: 1.5.2016
Kód zboží: NS-638200
Počet stran: 5
Přibližná hmotnost: 15 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
austenitic stainless steel, stainless steel tubing, steel tubing, welded steel tubing ,, ICS Number Code 23.040.40 (Metal fittings)
1. Scope | ||||||||||||||||||||||
1.1 This specification covers straight seam and spiral butt seam welded unannealed austenitic stainless steel tubular products intended for low and moderate temperatures and corrosive service where heat treatment is not necessary for corrosion resistance. Table 1 lists the five grades covered by this specification. The user of this specification should be aware that a minimum amount of testing and examination is required of the basic product. The user requiring additional testing or examination is referred to the supplemental requirements or Ordering Information, or both. Users requiring a tubular product with post-weld heat treatment or with radiographic examination are referred to Specification A312/A312M, A358/A358M, or A409/A409M, as applicable. 1.2 This specification covers welded
unannealed tubular products 3 in. [75 mm] through 48 in. [1200 mm]
in outside diameter and in nominal wall thicknesses of 0.062 in.
[1.57 mm] through 0.500 in. [12.70 mm] produced to this
specification. Tubular products having other diameters or wall
thickness, or both, may be furnished provided it complies with all
other requirements of this specification.
1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining the values from the two systems may result in non-conformance with the standard. The inch-pound units shall apply unless the “M” designation of this specification is specified in the order. |
||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||
|
Poslední aktualizace: 02.05.2024 (Počet položek: 2 896 910)
© Copyright 2024 NORMSERVIS s.r.o.