Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Carbon Steel and Low-Alloy Steel Pressure-Vessel-Component Forgings with Mandatory Toughness Requirements
Automaticky přeložený název:
Standardní specifikace pro uhlíkové oceli a nízkolegované tlakových nádobách složka výkovky závazných požadavků houževnatostí
NORMA vydána dne 1.5.2012
Označení normy: ASTM A765/A765M-07(2012)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.5.2012
Kód zboží: NS-4087
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
alloy steel forgings, carbon steel forgings, heat-treated, impact tested, intercritical heat treatment, pressure vessel, weldable , Alloy steel forgings--specifications, Carbon steel forgings--specifications, Feedwater heater tubes--specifications, Pressure vessel steel forgings--specifications, ICS Number Code 77.140.30 (Steels for pressure purposes)
1. Scope | ||||||||||||||
1.1 This specification covers heat-treated carbon steel and alloy steel forgings with mandatory toughness requirements. These forgings are intended for pressure vessels, feedwater heaters, and similar uses. 1.2 These forgings include tube sheets, covers, channel barrels, integral forged channels, rings, nozzles, flanges, and similar parts. 1.3 All grades are considered weldable under proper conditions. 1.4 The maximum thickness of forgings produced to this specification is limited only by the capacity of the selected grade to respond to any heat treatment specified and to meet the specified mechanical tests, including impact tests at the specified temperature. 1.5 Material supplied to this specification shall conform to the requirements of Specification A788/A788M, which outlines additional ordering information, manufacturing requirements, testing and retesting methods and procedures, marking, certification, product analysis variations, and additional supplementary requirements. 1.6 If the requirements of this specification are in conflict with the requirements of Specification A788/A788M, the requirements of this specification shall prevail. 1.7 The values stated in either inch-pound units or SI [metric] units are to be regarded separately as the standard; within the text and tables, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. 1.8 Unless the order specifies the applicable “M” specification designation, the material shall be furnished to the inch-pound units. |
||||||||||||||
2. Referenced Documents | ||||||||||||||
|
Historická
1.5.2014
Historická
1.5.2014
Historická
1.10.2010
Historická
1.10.2010
Historická
1.10.2010
Historická
1.3.2014
Poslední aktualizace: 22.12.2024 (Počet položek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.