Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Surface Insulation Resistivity of Single-Strip Specimens
Přeložit název
NORMA vydána dne 1.10.2022
Označení normy: ASTM A717/A717M-12(2022)
Datum vydání normy: 1.10.2022
Kód zboží: NS-1087767
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
coating, electrical steel, Franklin tester, insulation, resistivity, single-strip specimens, surface insulation resistivity,, ICS Number Code 29.035.20 (Plastic and rubber insulating materials)
Significance and Use | ||
5.1?This test method is particularly suitable for quality control in the application of insulating coatings. 5.2?Surface insulation resistivity is evaluated from a dc current that can range from 0 (perfect insulator) to 1 A (perfect conductor). 5.3?Single readings should not be considered significant since the nature of the test device and specimen are such that successive measurements of a specimen often yield different values. |
||
1. Scope | ||
1.1?This test method covers a means of testing the surface insulation resistivity of single strips or punchings of flat-rolled electrical steel under predetermined conditions of voltage, pressure, and temperature. 1.2?The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined. 1.3?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||
2. Referenced Documents | ||
|
Poslední aktualizace: 22.12.2024 (Počet položek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.